This is a custom designed replacement clamp arm for the cupholder in 2nd Generations Dodge Rams.

Most of the stock one are brittle and broken over time. This new designed one fits in place of the stock one and is make from UV resistant ASA (will come in dark grey/black)

Fuel Pressure Regulator mount that fits in the location of the alternator on the gen 3 hemi ram front covers. This will come laser cut in bare aluminum. Has enough room to run a 8AN return or possible larger below it and adjustments for height depending upon the regulator used (designed around a redhorse performance fuel regulator and bracket assembly).

Mount/cover all in one for proportioning valve for those mounting it under the car to better protect it. Has a removeable cover that utilizes two of the mounting bolts to mount to frame or location you desire. 4-Bolt mounting plate and allows for full range of travel of the adjustment knob. This works with speedway motors proportioning valve and should work for any others that are the same dimensions.

Item is 3d printed out of ASA which is a rigid plastic that is also UV resistant and can withstand heat for those putting on their daily drivers or drag and drive cars.

Fits: Gen 3 Hemi, mounting at the front timing cover where the A/C pump normally goes
Also fits: B-body Mopar with Holley engine mounts (requires some trimming of the stock K-frame steering box braces)
Made for: GM 1-wire alternator (not included)
Material: Aluminum, powder coated

Includes adjustment for both belt tension and belt alignment. Other applications may vary depending on alternator size and engine position, so message me before ordering if you're unsure it will fit.

Fits: Dual Mac valve setups with a T in the middle, the common twin turbo layout
Material: ASA plastic
Included: two-piece holder (mount and removable front cover)
Not included: top screw, Deutsch connectors, Mac valves and related pieces

Mounts with four bolts through the corner holes and protects the solenoids in the engine bay. The front cover comes off, with one optional screw on top, so you can adjust or replace the valves easily. The lower section holds a 4-pin female Deutsch connector for each plug, so unplugging from your harness is simple.

*Screw for top, deutsch connector & mac valves / pieces for them not included

Inserts for your 2nd gen ram 98-02 shifter console. The stock console is known for its issues with poor plastic and just being old. These are designed to fit in both cup holders. The larger one pops into place with the old adjustable arm removed from the console. Should use some super glue to permanently mount it but does hold well without it. The smaller cup holder is sized to fit a 12fl oz energy drink can snuggly in it. There is a whole in the bottom to allow for the stock mounting screw to be run and help hold it in.

These are printed in ASA and the smaller has a hole to put a screw though for the stock center console mounting location hole.

Fits: Klein square digital angle gauge (gauge not included)
Material: ASA plastic
Included: 3-piece holder with a bolt-on front cover and a universal round-tube bottom adapter

Protects your gauge and lets you mount it perpendicular to the part you're measuring. It's ideal for roll cage work where you twist the tube for an offset bend and need the angle right. The bottom adapter fits a variety of material and is replaceable, and I'll be releasing other ends for it.